Kohler Prosecco Flow Restrictor (2024)

FAQs

Is it okay to remove the flow restrictor? ›

While you can remove a flow restrictor from a showerhead, doing say may cause your shower to violate plumbing codes. The national standard for maximum showerhead flow rate is 2.5 gpm.

A flow restrictor will increase the pipe pressure on the upstream side of the restrictor. The increase in back pressure, coupled with the decrease in orifice size that the water can come through, results in a decrease in flow rate output (gallons per minute) but an increase in the flow speed and force.

Controls, Dampers, and Valves

A flow restrictor is a two-port valve that reduces the flow as the valve stem is lowered and the plug pushed onto the valve seat. The disadvantage of this type of valve is that flow may be entirely obstructed.

When it comes to Shower Heads, you'll typically find 2.5 GPM, 2.0 GPM, 1.8 GPM and 1.5 GPM. If you're looking for the most pressure, go for the 2.5 GPM Flow Rate, unless you are restricted because you reside in California, Colorado or New York. Again, this has been the Maximum Flow Rate since 1992.

The most common function of a flow restrictor is to meter the flow rate of the fluid or gas traveling through it. A simple example is a faucet used to control the speed of water flow into a kitchen sink or out of a showerhead.

The flow restrictor is usually blue or green, sets inside the fixture, and is easy to access. Often times it has a couple of tabs that can be grabbed with a pair of needle-nose pliers. Grab the tabis give it a tug, and the restrictor pops out. Check it for debris.

Soak the screen and other aerator parts in vinegar or CLR to dissolve mineral deposits (scale). It's best if you can leave the parts submerged in the vinegar overnight, but at the very least, soak them until the deposits are soft enough to be removed with a toothbrush or toothpick.

Install Flow Restrictors

Flow restrictors belong on all bathroom and kitchen faucets. Each one can save you up to 5,000 gallons, or about $10 every year. The Toilet is the biggest water user. If you hear your toilet constantly running, remove the tank lid and lightly pull up the float arm.

The flow restrictor limits the volume of water with its stable and fixed structure, whereas the flow regulator normalises the water flow with its contracting and expanding rubber washer.

What are the advantages of flow restrictors? Flow restrictors primarily limit the flow. According to experts, consistent use of flow restrictors can save 35%-65% of water used in industry. In addition, they ensure a constant flow, which is important for sensitive fittings.

Is it OK to remove the flow restrictor? ›

A: If done carefully, removing the water flow restrictor will not damage the shower head. However, be sure to follow the instructions carefully and do not use excessive force.

Inside every shower head is a small part called a flow restrictor or flow regulator. This part is designed to control the flow of water to the shower head and it has a significant effect on the water pressure in your shower.

SoCal water district installing flow restrictors in homes of customers who use too much water. What happens if you try to remove the restrictor device? The district said that will cost you a $2,500 fine.

A flow restrictor, as the name suggests, regulates the amount of fluid that can exit an outlet. Flow restrictors are used to control the volume of fluids, such as water or air, that flows out of a faucet or other dispenser.